Small 10x8x6 Wall Mount Metal Box Enclosure for Single Controller, one 1/16 din Knockout Hole on The Front, Indoor/Outdoor

This controller enclosure measures 10 x 8 x 6" (250 x 200 x 150 mm). A 1/16 can be installed with adequate room for wiring and switching device. The box is made of powder coated, 0.040" (1 mm) thick steel. One side of the wall has a pre-cut opening. It can be used for installing cables or heat sink. The door comes with lock and key. The hinges of the door are removable. It can be installed on either right or left side. This allows the user put the pre-cut opening either on top or at the bottom without changing the door opening directions. Gasket and plugs are provided. It is rated for IP65 before any wholes are cut. The enclosure is designed to be mounted on a wall. You can directly mount it with screws or hang it on the wall with the hangers (included). For high power circuit, wall mount box is preferred because the heavy cords (14 AWG or thicker) are difficult to manage with a table top enclosure. This enclosure comes with factory knockout hole for 1 x 1/16 DIN controller. This knockout hole can be easily removed and it will save a lot of headache for most users that don't have the special tool to cut it. User needs to cut some round holes for switches and connectors. But round shaped holes are much easier to cut on the sheet metal than the square holes are. The box has a pre-cut hole on the top for external heatsink (not included). A top cover plate is included. User can use that cover plate to cover the top hole if not use. Please note: PID controller is not included.

• 10 x 8 x 6" Enclosure
• Factory knockout hole for 1 x 1/16 DIN sized controllers
• 1.5 mm thick steel, powder coated
• Removable door with lock and key